AcrylicNominal power10 W
Black opaque acrylic 3 mm — Cut with xTool F1 · 10 W blue-light module
Directly sourced starting point for cut with xTool F1 · 10 W blue-light module.
Single sourceStarting point, not a result guarantee
Context used for this setting
Context used for this setting
- Laser technology
- Diode laser
- Nominal power
- 10 W
- Material
- Black opaque acrylic
- Thickness
- 3 mm
- Goal
- Cut
Starting values
Starting values
Power100 %
Speed2 mm/s
Passes1
Do this
- Match material, thickness and laser module exactly.
- Test the value on comparable scrap first.
Avoid this
- Do not transfer values to other power classes or material variants.
Check before you start
Check before you start
Extra cautionProcess clearly identified chlorine-free acrylic only. Never laser PVC.
- Chlorine-containing plastics release toxic and corrosive gases.
Approach the result safely
Approach the result safely
Start on a comparable scrap piece. Change one parameter at a time and document the result before moving to the final workpiece.
This value comes from an openly licensed dataset referencing the official xTool material table. Always run a test patch first.
Sources and confidence
Sources and confidence
Single source
- Confirmations
- 1
- Updated
- August 21, 2026
- Shared by
- Open-source curation
Similar settings
Similar settings
Laser engravingEngrave
Clear acrylic 3 mm — reverse engraving
Bright frosted engraving from the back for signs and display pieces.
- Power
- Power18 %
- Speed
- Speed400 mm/s